SKU: 66664417704

Porterfield Brake Shoes for 2004 TOYOTA CAMRY 4 Cyl w/Rear Drums

$152.10 $169.00
Save 10%
No.2 Bestseller on nasasuma.com >

Pay in installments of $42.25 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 29 - Aug 3

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Porterfield Brake Shoes for 2004 TOYOTA CAMRY 4 Cyl w/Rear DrumsPorterfield Brake Shoes for 2004 TOYOTA CAMRY 4 Cyl w Rear Drums Porterfield R4 Porterfield R4 Carbon Kevlar based brake pads were fully designed for heavy duty extreme motorsports use. Its one of the the few true motorsports competition pads available on the market today. The carbon based semi metallic R4 brake material allows the brake pad to absorb huge amounts of heat and dissipate it quickly and evenly over time. The Carbon Kevlar material also

Porterfield Brake Shoes for 2004 TOYOTA CAMRY 4 Cyl w/Rear Drums

Porterfield R4

Porterfield R4 Carbon Kevlar based brake pads were fully designed for heavy-duty extreme motorsports use. Its one of the the few true motorsports competition pads available on the market today. The carbon based semi metallic R4 brake material allows the brake pad to absorb huge amounts of heat and dissipate it quickly and evenly over time. The Carbon-Kevlar material also allows the brake pad to heat up to operating temperature right away so little pad warmup is required for optimal operating condition. This compound also requires very little bed-in so that one is able to change out the pads and almost immediately able use them to their full potential.

R4 series provides high initial bite for immediate brake response while yielding extremely consistent modulation and predictability. This is great for all road courses, oval track, rally, vintage racing, autocross, club events, and professional driving events. This is one of the best motorsports pads we have used. Available for many applications, so please contact us if you do not see one for your car.

Porterfield R4-1

The R4-1 Vintage Full Race Compound was developed using knowledge testing in the vintage racing community. Optimum uses for the R4-1, under conditions where very high friction is needed with minimal warm up time and in applications where there is difficulty in maintaining sufficient heat with conventional race pad compounds. Widely used on vintage GT and formula cars the R4-1 is also gaining popularity in off-road and rally-cross classes. Great modulation, consistent pedal feedback and rotor friendly at all temperatures as with all the other Porterfield Carbon Kevlar compounds.

Porterfield R4-E

The R4-E Endurance Race Compound is a carbon kevlar compound made to last a bit longer than the original R-4 compound. The R4-E compound is designed to endure higher prolonged temperature and still has pad life as long or longer than Porterfield R-4 do. This pad is great for club enduro events and applications where temperatures are at their maximum.

Porterfield R4-S

Porterfield R4-S high performance street and autocross brake pads are great for heavy-duty street and light track applications. Compound is perfect for everyday use while still keeping the highly capable track ready performance. The R4-S features a high friction level that will increase your stopping power with minimal pedal effort.

The R4-S series pads are VERY VERY rotor friendly and yield very low levels of dust; levels are far below OEM equipment or any other high performance brake pads. Your car will stop better and your wheels will stay cleaner longer. Good for autocross, rallies, driving school, and of course daily driving with a little extra stopping power. R4-S pads are available for virtually all vehicles sold in the US and custom R4-S pad sizes for competition style calipers are also available.

This is one of the very best all around street/strip brake pads available at a great price.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 66664417704

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.4 ★★★★★
Based on 22 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
D
Verified Purchase
David Spencer
Cuba, US
★★★★★ 5
Good stuff
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Good stuff, easy to use, self adhesive backing contours around curves easily and works great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 29, 2026
S
Verified Purchase
stookie778
Charlottesville, US
★★★★★ 5
Works amazingly, but only if you install it correctly.
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
If you purchasing Siless Liner 157 mil (4 mm) Sound Deadening mat, to block unwanted sounds in your car, this is what you need to buy. But wait! It's not the only thing you need to buy if you want to "actually" deaden sound. By itself, it will definitely block a noticeable amount of sound, and, most likely, that's all you realistically need. But... But... If you want the Siless Liner Sound Deadening Mat to really help you take it up a few notches, to get the best sound almost bordering on soundproofing, listen up. You will have to install traditional butyl rubber first. Doesn't have to be the Siless brand, but I'm sure they would love to sell both to you, I used both Killmat (80mil) and Noico (50mil). I have a Honda S2000. It's a two-seater convertible sports car if you don't know what this car is, and it's loud when I'm driving above 60mph. I also happen to have a sound system installed as well. Other than that, the car is stock. I first installed the butyl rubber on the car's interior sheet metal. I went all out and covered everything I could. I didn't need to but I wanted to. I was extremely impressed with the results. But I wanted to go further. Not because I needed to but because just wanted to see what it would be like. So I bought Siless Liner 157 mil (4 mm) 36sqft Sound Deadening mat to go on top of the butyl rubber mats. I put this over every area I installed the butyl rubber. I had to be careful of clearance issues since I added a significant amount of underlayment, and you should too. If you put butyl rubber sound-deadening materials in 50% of the total interior area, you'll hear a noticeable improvement. If you put butyl in about 80% of the total area, you'll be even more amazed at the improvement, compared to before. I originally did all the above myself, so that's my experience and so your mileage may vary. I then installed the Siless Liner Sound Deadening mat over every place I could even going further than I could with the butyl rubber. I used the Siles Liner in areas where butyl rubber would not have been effective, such as the roll bar hoop area and large empty cavities or holes. I covered everything I could, firewall, doors, floor pan, transmission tunnel, trunk, trunk lid, fuel tank area, rear quarter panels, and rear-wheel tunnels, in Siless Liner Sound Deadening Mat. WOW!! The Siless Liner Sound Deadening Mat was the icing on the cake! Let's not forget, this car is a convertible sports car so it will never be a quiet ride, ever. But I can now actually have a conversation with a passenger at a normal-ish volume! This also means I can now have a normal hands-free phone call without having to plug one ear to block out the noise! My sound system sounds so much better! Just by going through the install process, I looked for any vibration, rattle, squeak, and noise-prone areas to either eliminate or reduce unwanted noise production. If you forget this step, the inside and outside of your car will rattle and buzz. I skipped this step the first time around. But did it right before I installed more butyl rubber and the improvement was impressive, especially inside the car. Outside the car, I didn't notice a difference until I put the last layer of Siless Liner Sound Deadening Mat. The sound deadening mat works both ways from what I can tell. If I turned up my music, as loud as I occasionally do, parked in the attached garage to the house, with the garage door closed, I would be barely able to tell the car was playing music in the garage. It sounds like it is another car, just a little bit down the street, with a very loud base. If you stand 20 feet away outside the car, the sound system is noticeable, but not obnoxious by a long shot. Get a 3 piece wood/metal roller set as well, which makes quick work of large areas.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 23, 2021
L
Verified Purchase
Ligia
Natrona Heights, US
★★★★★ 5
Better than Kilmat
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Great adhesion, and you can immediately see the sound difference when you rap the area and compared it to another area without it. Also, very easy to cut and apply. Once on, you may not be able to peel it and reposition it, so be sure where you want it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 2, 2026
J
Verified Purchase
J M.
Birmingham, US
★★★★★ 3
Not much noise reduction…
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Easy to install but did not provide much sound dampening…
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 28, 2026
T
Verified Purchase
Travis McKinstry
Waukegan, US
★★★★★ 5
High quality, super sticky, very effective
Style: 30 sqft
As long as the surface is thoroughly cleaned, these mats will stick to just about anything. They provide my car with a tremendous amount of sound dampening and have made riding in the car 10 times more enjoyable. I drive a Toyota Yaris and although the engine is built like it's meant to last forever (imagine that), the rest of the car is not of high quality. Which means we used to get A LOT of noise coming from the road, other cars, etc. After I installed these mats which, by the way, I wasn't able to install on every surface I wanted to install them on (due to lack of tools to be able to disassemble certain parts of the interior), the noise coming from outside the car is nearly completely gone. I covered the underside of my hood, the entire interior part of the hatchback, most of the floor in the trunk / spare tire well, and the entire interior side of the doors. The parts I couldn't get to (or didn't want to) were: the ceiling, underneath the driver & passenger seats, behind the dash and the floor for the 2nd row seating. As you can see I left a lot of surfaces untreated with this product AND STILL it blocks most of the sound. To note: people recommended getting the roller tools to help install these mats. I got a few of them in different sizes and they worked O K. Not because of the quality of the tool but because some places you need to install these mats in don't have enough clearance to use the tool. That being said, for the larger surfaces, the roller tools help a lot. Also I found it very beneficial to use aluminum tape while installing these. The tape I used is specifically designed for materials that undergo high temperature changes (like your dryer vents, etc.). This wasn't because the mats were not sticky enough but because there were some places I installed the mats with small gaps between them. I'd also recommend getting some kind of fluffy insulation-type material for large spaces that need noise dampening. Rock wool, for example, worked great for me. As an example, the interior sides of the 2nd row seating walls had large spaces between the plastic interior cover and the metal part of the car wall. I'd install the mats on the metal but was left with 6" - 7" of space between it and the plastic cover. I chose to fill those spots (and spots like it) with insulation which provided EVEN MORE noise dampening.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 25, 2024

recommand products

METCAL DFP-CN4 Desoldering Tip, MFR-HDS Series Desoldering Handpiece, Round, 2.3 mm
4672.14
Samsung Galaxy S21 Plus Battery Replacement
65.00
Sadar Dawakhana Laboob Kabir - 250 gm
197.50
IWB / OWB / SOB Holster Clip-On / Belt Slide, Ambidextrous Compatible w/ Glock 33
23.99
SCHNEIDER ELECTRIC / TELEMECANIQUE LRD21 Overload Relay, TeSys D, Thermal, 12 A, 18 A, LRD Series
6500.61