Hobbywing XRotor Micro Combo Stack (F7 FC + 40A BLHeli_32 ESC)

Hobbywing XRotor Micro Combo Stack (F7 FC + 40A BLHeli_32 ESC)The XRotor Micro Combo from Hobbywing continues to impress with its latest iteration. The Micro Combo features a 40A 4 in 1 ESC along with an updated F7 Flight Controller. This new FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system. Make your electronics stack work for you, not the other way around! Manual

The XRotor Micro Combo from Hobbywing continues to impress with its latest iteration. The Micro Combo features a 40A 4-in-1 ESC along with an updated F7 Flight Controller. This new FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all-new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system.

Make your electronics stack work for you, not the other way around!

Manual

• XRotor Micro F7 Flight Controller Manual
• XRotor Micro 40A 20x20 ESC Manual

Features

F7 FC

• Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor.
• Supports BetaFlight, Cleanflight, Butterflight, Inva, and other mainstream FPV firmware.
• DJI image transmission system port equipped with corresponding flat cable
• Supports bidirectional DShot digital throttle communication.
• Unique installation design and shock absorption structure.
• On-board large capacity Flash memory chip.
• On-board 5V & 12V dual BEC circuit.
• On-board Pit Switch module.#

40A 4-in-1 BLHeli_32 ESC

• All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
• The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us), and Multishot (5-25us).
• Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up.
• High-performance 32-bit microprocessor with a running frequency of up to 48MHz for an excellent performance.
• BLHeli_32 firmware is the third generation BLHeli.
• Unique Soft Mounts

Specifications

F7 FC

• Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc
• Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
• Mounting Holes: Convertible 20x20mm / 30.5x30.5mm
• Programming via: Betaflight/Cleanflight-configurator
• Firmware: HOBBYWING_XROTORF7CONV
• Voltage Monitoring: Supported
• Current Monitoring: Supported
• FC Programming: Supported
• External Buzzer: Supported
• BEC: [email protected]: [email protected]
• LED Control: Supported
• USB Port: MicroUSB
• Size: 32x32mm
• OSD: Built-in
• Weight: 3.3g

40A 4-in-1 ESC

• Connectors: (In) XT60 (w/ Wires Soldered on) / (Out) No
• Input wires: 14AWG-100mm* (Red/Black)
• Output Wire: No wires but solder tabs
• Weight / Size: 12.0g / 40x33x5mm
• ESC Programming: BLHeliSuite32
• Throttle Calibration: Supported
• Mounting holes: 30.5x30.5mm
• LiPo Power input: 3S-6S
• Burst Current: 60Ax4
• Cont.Current: 40Ax4
• BEC Output: No

Included

• 1x Hobbywing XRotor Micro Combo Stack - F7 FC + 40A 4-in-1 BLHeli_32 ESC
• 1x Soft Mounting Grommets Set
• 1x Signal Cable